Class : Apprenti
Posts : 47
Registered on : 11/04/2008
Off line
What is wrong here, I can not adjust the dots on my screen, They are still white with a lot of crosses in it.
point diameter 2/26 min/max pixels, adjustments here no effect only to the amount of crosses.
The dots on the lower screen side are red and sometimes flashing to green
Class : Apprenti
Posts : 21
Registered on : 19/08/2009
Off line
If the dots at the bottom are flickering green you're probably very close to a good setup. I would keep trying with adjusting the slider settings of the camera control. These are the settings that work best for me:
[advanced]
- disable automatic gain control!
- keep exposure as low as possible to get the highest framerate
- keep gain to zero if possible
- anti flicker: as appropriate for your system
- image enhancement - all disabled
[device settings]
- set brightness to highest possible level that still only produces 3 dots
- set contrast to highest possible value, lower if multiple crosses appear
- saturation to minimum value
- sharpness minimum value, to avoid multiple crosses per led
- white balance/backlight comp to zero
Make sure that your leds get enough voltage, and you did not mention if you had made the IR mod on your camera.