FreeTrack Forum
|
Hi all,
I built my 3 point cap about a month ago, but when I turned my head from left to right I would lose tracking. So tonight I decided to sand the LEDs down more, because when I had done it before I didn't go down too far. I used a dremel tool with a sander bit on about half power. I've read here on the forum that you should sand down to just above the metal. I didn't feel safe about going that far down, so I'm well above the filament, but look what happened...  The LEDs are grey now... Did I shave away some kind of coloring layer? Is there a way I can make FreeTrack reognize grey instead of red?  Also, what's with the grey bar at the bottom? I don't remember that before I shaved my LEDs. |
|
|
Yes.
I can move it all the way up and all the way down. No change in color or size of the LEDs. Overall, the performance of the newly shaved LEDs is a hundred times better than before; except that they don't work. |
|
> Stats
1 user(s) connected during the last 10 minutes (0 member(s) and 1 guest(s)).