FreeTrack Forum

I reinstalling the previous FT 2.12, and works very good.
Enybody works in FS2004 all the 6 axis ?

I think that it is important: if you installed new FT2.2 software you HAVE TO set camera properties again. And NOT ONLY source, format and resolution - go to camera settings and set proper gain, no auto focus and whatever is needed to get good LEDs view, similarly as it usually had to be done in FT2.1.

So - not only general or profile settings, camera ones as well!

Best regards,
Sorbifer.

After 20 mins or so setting up, the wii remote works fine. I think the translation problems were down to config problems, nothing else.

I'm still getting JPS jumping around 50-100 though, anyone else getting this with a wii remote setup?

All the guys who have problems with low cam FPS/choppy performance: enter your cam settings (camera option when cam is active) and check if all the settings are the way you left them the last time this screen was active. I've found out that I need to set a few things again every time I start FreeTrack as the cam didn't remember saved settings from the last time (v2.1 didn't do this). I didn't check with multiple cams so I don't know if this happens with all the webcam model out there...

IL-2 works just great with v2.2, no problems at all, but when I exit Lock On Flaming Cliffs I get a memory read error and Lock On crashes. Everything works fine, but crashes when I hit the exit button %-)... Haven tried it with anything else yet... I still have a single point tracker so I don't know if there would be problems with a 3 points tracker.

Anyways, the memory read error made me feel uneasy so I went back to v2.1 and screwed with the settings until I got it to work alittle more like v2.2 as I really liked the speed and precision of the new version....

Cant access the camera properties in FT. It comes up but there are no options. But if I go into the trust program all settings are set to zero. I set them back, use ft still no good. Go back to trust software and everything is zero again. If I go in and out of trust software it doesn't keep zeroing settings. Using a trust WB-1400.