|
Class : Apprenti
Posts : 8
Registered on : 30/01/2012
Off line
|
All the pictures of tracking hats that I've seen look really nice, with Knex or 3D-printed clips and everything.
All I did was solder 3 IR LEDs in parallel to a switch and a single AA battery (no resistor). The easiest way I could think of to attach them to my baseball cap was with duct tape.
But duct tape on fabric isn't exactly very stable/steady. The LEDs will be in slightly different positions (relative to each other) every time I put the hat on, from the fabric and duct tape moving around, and the LED's moving around underneath the tape.
Are there any specific problems that this could cause?
|
|
Class : Moderator
Posts : 656
Registered on : 16/11/2007
Off line
|
Hi,
stay in the limit of +-5mm of what you have fill in for the model dimensions and positions will be acceptable. But of course every difference leads to a wrong tracking behaviour.
|